Our urban disposal solutions contribute significantly to effective and efficient waste management, and enhance the well-being of residents and building operators. Our solutions are always environmentally sustainable and in compliance with the applicable regulations.
Although disposal is about getting rid of something without a return, our experience demonstrates that sustainable management of household waste can result in more benefits for our customers.
EMERGENCY STOP BUTTON
Standard on all models, twist and release operation to shut off power in the event of an emergency.
DURABLE PUSH BUTTON PENDANT
Low voltage push buttons with a positive action and strain relief wire, moulded into the pendant cable for added support and durability.
Equipped with a sanitizing liquid tank and dosage pump which injects degreaser and a disinfectant solution into the water flow that is sprayed inside the chute.
An extra Pendant control lifts/lowers the brush unit manually for maintenance.
The brush has a rubber cylindrical housing with embedded stiff nylon brushes which are lowered and raised by a geared electric motor.
The nylon brushes scrape and clean the internal surface as they move up and down in the chute.
The flushing spray head at the top of the chute and the floors disburses a cleaning solution down the inside of the chute to control odours and bacteria.
The safety interlocking check mechanism ensures no doors can be opened unless the cleaning cycle is completed and the brush is in its designated place at the top.
ATTENTION TO DETAIL
Chute Doors are supplied with a 24V electric strike with a micro-switch to indicate a door status change (open or closed). This feature enables monitoring the status of doors on different floors. It also allows for electrically locking of the hopper doors for chute maintenance or interlocking when one of the doors is open.
The leakproof chute trunk has a smooth surface and is welded seamlessly. There are no bolts, rivets nor projections protruding into the chute. A 2mm Sound deadening coating is applied on the exterior of the chute that inhibits any unwanted noise from falling garbage. As an Option an extra 25mm foil faced fiberglass insulation coating is wrapped around the exterior of the chute.
600mm diameter, 1.5mm thick SS 304 is standard. Recommended due to its resistance to alkalis, acids and humidity which may occur in waste chutes.
BLAST PROOF VENT CAP
Stainless Steel 304 Vent extends above the roof by Minimum 1200mm with an NFPA compliant blast cap. Ventilation of the chute is required to extract the foul air to the atmosphere through the opening of the chute system. The full diameter vent comes complete with roof flashing, riser and metal safety cap.
The discharge is a UL labeled 1 1⁄2 Hr Fire Rated Accordion Damper held open by a 72°C fusible link and equipped with tension coils on either side of the damper to permit closing in case the link breaks.
An inclined guillotine Type Shutter Door held open by a U.L. listed fusible link. The fire door will roll shut if the link is melted. The 4mm safety plate can also be used as a safety plate for protection from falling objects during the replacement of the trolleys.